username is admin, password is maxlinear. Set your IP manually and the web admin page will load. You need to set your IP address manually to 192.168.144.1, subnet 255.255.255.0 because the adapter does not have DHCP server. The admin / config page will not load at all, page just times out. Another is for TV, between MoCA RF port and the TV RF port. One is for MoCA, between the MoCA chip and MoCA RF port. Yes, our adapter has two internal band pass filters. So we don’t need to do the certification again.ĭoes your MoCA adapter includes a filter inside the device already, such that connecting Modem/TV/etc to the second (marked TV) coaxial connector of the device will filter out MoCA frequencies? Our product is based on their MoCA 2.5 chip, Mx元710. Their reference board has passed MoCA 2.5 certification. Now only Maxlinear is making MoCA2.5 chip. Is your product MoCA certified by the MoCA Certification Board ? MoCA technology works with any network access technology including fiber (GPON/EPON), DOCSIS, Ethernet and MoCA Access You can change our device to use D-band high only, from 1350MHz to 1675MHz, can build a 3-channels connection.ĭoes MoCA work with any network access technology? We know that, many MSO use D-band low 1125MHz to 1225MHz to act as MoCA WAN. It will setup a 5-channels connection, from 1125MHz to 1625MHz. Our device can support MoCA D-band low, D-band high and D-band extend three configurations. At the same time, if you have another pair of nodes on the same network that both support MoCA 2.0, then that pair will communicate at 2.0 speeds.ĭoes the admin GUI also allow configuring the MoCA frequency channel you want the extenders to run on? This means, if a MoCA 1.1 device is talking to a MoCA 2.0 device (or 2.0 2.5, etc.) then the speed drops down in both directions to what the 1.1 device can support. Per the MoCA specification, MoCA devices are backwards compatible but not forwards compatible. Will these work in an existing MOCA 2.0 environments? Obviously would have update at least 2 ends of the splits but would other ends be required to have 2.5 or would older MOCA adapters work with these? The elected controller device manages the Tx/Rx time slot allocation. The 2.5 Gbps is shared by all the devices in the same network. Yes, our device can pass packets with VLAN tag. Can your MoCA devices bridge 802.1q VLAN tagged packets?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |